VARIO-CARE PROTECT 1,0 l

Special water-based polymer coating, matt finish, for the care and refreshment of thoroughly cleaned or newly installed, non-absorbent floors. Suitable for residential and commercial use.

Suitable Substrates

• PVC / LVT.

• PU-coated surfaces (factory-made or handcrafted).

• Sealed wooden floors.

• Other floors (PU/EP coatings, polyolefin, rubber, stone) subject to site-specific assessment.

Note: Maintenance instructions for specific substrates are available at Download.

Application

• Thoroughly clean the floor before application

• Shake the product well.

• Apply undiluted in a thin, even layer at a minimum of 15 °C.

• Repeat application for enhanced protection once the care film is walkable.

 Notes:

• Avoid strong sunlight and drafts during application.

• Turn off underfloor heating beforehand.

• Remove excessive care product layers through occasional deep cleaning.

Consumption

• Initial care/refreshing: 25-30 g/m² per application (coverage: 30-40 m²/l).

• Maintenance cleaning: 0.1 liters per 100 m².

Drying Time

• Walkable after 30-60 minutes (water evaporation).

• Fully usable 12 hours after the final layer has dried.

Storage

• Protect from frost.

• Store cool and dry.

• Keep out of reach of children.

Special Instructions

• Use only products from the same batch.

• Pre-tests for film adhesion and coverage are recommended.

• Care film cannot transform glossy surfaces to matt.

• Special procedures for Antislip surfaces required.